TECHNICAL DESCRIPTION 

Window A1 Clipper

• Braced self-supporting 47 mm thick partition with single wall.
  Lacquered aluminium top and bottom wall plate, 35 mm high including the glazing bead.
• Ceiling bearer, as a variation of the lacquered aluminium profile top wall plate. With a width of 47mm including a hollow joint to accommodate the glass pane and 2 resting flanges for the ceiling panel. Suspended using a standard ceiling runner.
• Lacquered aluminium walls’ start, 35 mm wide including the glazing bead.
• Single glazing 6 to 12 mm thick with clear polished edges, laminated or tempered depending on the size of the volume. Glazing rebate held on 2 sides (top and bottom). The vertical connections between glass panes are provided by a flush silicone joint.
• Lacquered aluminium glazing bead assembled via direct clipping on the wall plates.
  EPDM glazing joint on each side of the glass panes, thickness: dependant on thickness of the glass panes.

• 2D or 3D right angle made from lacquered aluminium profile + glazing bead mounted on the wall plate via connection and ceiling bearer via bearer corner block.
• Lacquered aluminium door frame, 50 mm thick, fitted with an isophonic joint and a groove to accommodate reversible hinges.
• Installed between lacquered aluminium uprights, bonded by the “reinforcement”, on the ceiling bearer.
• 40 mm thick wooden door, clarit or aluminium frame.

Ceiling bearer variation

• Ceiling bearer, as a variation of the lacquered aluminium profile top wall plate. With a width of 47mm including a hollow joint to accommodate the glass pane and 2 resting flanges for the ceiling panel. Suspended using a standard ceiling runner.
• Angles and uprights mounted on the ceiling bearer via bearer corner block.