Clipper S5

• Braced self-supporting 82 mm thick partition with double facing.
• Lacquered aluminium top and bottom wall plate, 40 mm high.
• Aluminium upright of section 47x37 with steel clips allowing the indirect mechanical clipping of the cover strip.
• Lacquered aluminium cover strip, 37 mm wide, flat or omega 5 mm visible thickness, fitted with a 10 mm wide PVC spring ring.
• Facing panel, 13 mm thick covered plasterboard (vinyl, fabric, painting) or 12 mm wood panel (melamine, laminate, coated with fine oils)
• Glass wool insulant, 45 mm thick.
• Single or double glazing, 6 mm, 8 mm, laminated 33.2 or 44.2 closable pane on isophonic joints.
• 25 or 16 mm Venetian blind to be integrated in the single or double glazing module.
• 40 mm thick wooden door, clarit or aluminium frame
• Lacquered aluminium door frame fitted with an isophonic joint and a groove to accommodate reversible hinges.
• Single-piece glazing transom made of lacquered aluminium, 40 mm high or primary aluminium composite + flat or omega cover strips, mounted on the uprights using junctions or connections.
• 2, 3 or 4 direction right angle or variable angle with round post and angle profiles allowing to make any angle starting from 90°.
• Electric cable built-in in the core of the partition or aluminium electric plinth 82 mm wide, 80 or 160 mm high, allowing the direct clipping of electrical equipment. The plinth is installed as a bottom or vertical wall plate

 Clipper S7 variation

• Braced self-supporting 82 mm thick partition with double facing.
• Lacquered aluminium top and bottom wall plate, 40 mm high.
• Aluminium upright of section 72x37 with clipping grooves allowing the direct mechanical clipping of the cover strip.
• Flat cover strip 37 mm wide with a visible thickness of 5 mm