|
Clipper S9
The S9 partition is a variation of the S range partition.
The whole frame structure is identical and only the wall mounted panels provide this high quality finish aspect, the hollow joint.
To underline or erase the partition. Choose the hollow joint, vertical or horizontal.
Covered using every panel type available on the market, laminated melamine or cladded with genuine wood, 16 or 19 mm thick.
S9 one or two sides
The use of a frame structure from the S range allows to have an S9 finish on either one or both sides of the partition.
The customisation of an office or passageway in an arrangement of standard partitions is easy and economical.
|
TECHNICAL DESCRIPTION
- Braced self-supporting 115 mm thick partition with double wall. Lacquered aluminium top and bottom wall plate, 40 mm high.
- Aluminium upright of section 72x37 allowing the direct mechanical clipping of the cover strip.
- Lacquered aluminium flat cover strip 37 mm wide and 5 mm thick.
- Aluminium transom made based on a rough S5 upright at a level of + or - 100 mm from the base wall plate.
The connection with the uprights is provided by fine level adjustment connections.
- Bottom clips screwed at the back of the panels,
intended to take over the load of the panel on the transom and to guarantee the hollow joints’ aplomb.
- Side clips screwed at the back of the panels intended to guarantee the gripping of the panels on the vertical uprights.
- Wood panels, 16 mm thick wall mounted to the frame structure by mechanical clipping and with a 10 mm hollow joint formed between the panels.
- Glass wool insulant, 70 mm thick.
- Single or double glazing, 6 mm, 8 mm, laminated 33.2 or 44.2 closable pane on isophonic joints.
- 25 or 16 mm Venetian blind to be integrated in the single or double glazing module.
|
- 40 mm thick wooden door, clarit or aluminium frame.
- Lacquered aluminium door frame fitted with an isophonic joint and a groove to accommodate reversible hinges.
- Single-piece glazing transom made of lacquered aluminium,
40 mm high or primary aluminium composite + flat cover strip mounted on the uprights using junctions or connections.
- 2, 3 or 4 direction right angle or variable angle with round post and angle profile allowing to make any angle starting from 90°.
- Electric cable built-in in the core of the partition or aluminium electric plinth 82 mm wide, 80 or 160 mm high,
allowing the direct clipping of electrical equipment.
The plinth is installed as a bottom or vertical wall plate.
Clipper S9 strip board variation
- Aluminium strip boards fixed to the first facing made of 12mm thick particle board.
- Inner strip boards mounted at the back of the covering panel.
|
|
